Operation mode and of the group control system of

2022-08-08
  • Detail

Pumped storage power station group control system unit operation mode and control hierarchy

pumped storage power station, as a special form of hydropower station, uses the excess electricity of the power system to pump water from the lower reservoir to the upper reservoir, and generates electricity during the peak load of the system. It has the dual role of peak load regulation and valley filling, and is the most ideal peak load regulation power supply of the power system. Pumped storage power station can also undertake the tasks of frequency and phase modulation, voltage regulation and emergency standby, which plays a major role in ensuring the safe and high-quality operation of electricity and improving the economy and stability of the system. Therefore, pumped storage power stations are generally used as power stations with direct power dispatching, which are controlled by the general dispatching. At present, most of the pumped storage power stations that have been put into operation or are under construction in China adopt advanced distributed control system (DCS), which provides software and hardware conditions for realizing group control at power station level and dispatching level. The continuous development of power system communication network also provides a strong foundation for real-time information transmission

operation mode and control layering of the unit

operation mode of 1 unit

each unit has three operation modes, namely, group operation, clamping the first end of the sample into the jaw at least 4/5 length, single machine operation mode and test operation mode. In the group control mode, the local control unit (LCU) of the unit controls the operation of the unit according to the instructions of the station computer. The setting of group control mode is based on the remote control of the unit

under normal circumstances, the unit that does not participate in group control selects the single machine operation mode, and the unit will automatically switch to the test mode after tripping. When the local control mode is selected for the unit, the unit is also set as the test mode. In order to simplify the design, the definition of test mode can be canceled, and the status of all units except "group operation mode" can be defined as

"single machine operation mode"

2 unit control hierarchy

the unit control hierarchy can be divided into local control layer, power station control layer and dispatching control layer. When the control mode knob on the local panel and cabinet of the unit selects "local", the unit called J can "automatically" or "step by step" execute the operator's command through the local control interface, and can also be controlled by the local control panel button, which is "local control layer". When "remote" is selected, the control right of the unit will be handed over to "power station control layer", and the unit operation mode is single machine by default. "Power station control layer", group control is set with two working modes, "monitoring mode", and the other is "automatic mode". In order to realize group control, group "automatic mode" should be selected first, and then "group operation mode" should be selected for the unit that needs to be added to the group for extrusion processing of general materials. At this time, the operator can also choose "local" on the deletion of the power station level as needed, leaving the control right at the power station side; Or select "remote" to transfer the control right to the General Dispatching side

after the General Dispatching side obtains the control right of the power station, the "dispatching control layer" can realize the demand for the total active and reactive load of the power station, especially the demand for ultra-fine fiber PU leather will become larger and larger, and the titanium dioxide leaders will exert efforts to manage the control of raw materials

Copyright © 2011 JIN SHI